The hardest question about an ageing skylight is not how to fix it. It is whether fixing it is worth doing at all. Every autumn, skylight replacement Aurora homeowners consider gets postponed for another year because a contractor offers a cheaper repair, and in perhaps half of those cases the repair is the wrong call. The unit comes back with the same stain the following October, and by then the same money has been spent twice.
This article gives you a decision framework rather than a sales pitch. Five questions, answered honestly, will tell you which side of the line your skylight sits on, and the cost tables below show what each path actually costs over the next decade.

The Skylight Replacement Aurora Decision In Five Questions
Contractors often present this as a technical judgement that only they can make. It is not. Five questions cover almost every case, and you can answer four of them yourself from the ground and from inside the house. The fifth needs a quote.
- Is the glazing seal intact? Look for haze or moisture between the panes.
- How old is the unit compared with the roof around it?
- How many times has it already been repaired?
- What would a proper repair cost relative to a new unit?
- What do you actually want the room to do?
Work through them in order. The first three often settle the matter on their own, and where they do, the skylight replacement Aurora question answers itself before anyone gets on a ladder.
Question One: Is The Glazing Seal Intact?
This is the fastest test in the skylight replacement Aurora decision and the most decisive. Stand under the skylight on a bright day and look at the glass. If you can see a permanent milky haze, a tide mark, or droplets that are clearly between the two panes rather than on the inside surface, the insulated glass edge seal has failed.
There is no repair for that. The argon fill has escaped, the desiccant in the spacer is saturated, and on residential skylights the glass and the frame are supplied as a single sealed factory assembly. Cleaning does nothing, resealing the perimeter does nothing, and drilling the unit, which is occasionally suggested, ruins what insulating value is left. If the answer to question one is that the seal has gone, stop here: replacement is the only honest outcome.
Be careful not to confuse a failed seal with condensation on the room side of the glass, which does not on its own justify skylight replacement Aurora work. Condensation sits on the warm inner surface, wipes off, appears on cool mornings and worsens after showers or cooking. It points to a shaft that needs air sealing and insulation, not to a failed unit.
Question Two: How Old Is The Unit Compared With The Roof?
Skylights and roof coverings have broadly similar service lives, which is the second thing that shapes a skylight replacement Aurora decision and which is why they should ideally be replaced together. A modern glass unit gives roughly twenty to thirty years, an acrylic dome rather less, and a typical asphalt shingle roof in the Greater Toronto Area falls in a similar band.
The problem case is a skylight that was left in place during a recent re-roof. The shingles have decades left and the unit does not, which means the roof will have to be reopened around a brand new covering within a few years. That is the most expensive sequence available, and it is why we recommend skylight replacement Aurora projects be timed with roof work wherever the two are within a few years of each other.
The reverse case is a sound unit under tired shingles. Here it is usually worth waiting and doing both at once, unless the skylight is actively leaking, in which case a targeted repair now and a coordinated replacement later is reasonable.
Question Three: How Many Times Has It Been Repaired?
One repair before considering skylight replacement Aurora work is normal. A flashing detail was wrong, it got corrected, the problem stopped. Two repairs on the same unit for the same symptom is a warning. Three is a verdict.
Repeat failures, the clearest trigger for skylight replacement Aurora crews see, almost always mean one of two things. Either the roof deck around the opening has softened, so new flashing has nothing solid to fasten into and works loose within a year, or the frame itself has deformed and no longer presents a straight, square edge for the flashing to seal against. Neither is fixable by adding more sealant, and both are cured permanently by taking the unit out, repairing the deck, and setting a new one.
Keep your invoices. If you cannot remember how many times a skylight has been worked on, the paperwork will tell you, and a pattern of small repair charges over several years is usually the clearest argument for replacement anyone can show you.

Question Four: What Would The Repair Actually Cost?
Here is where the skylight replacement Aurora numbers come in. Compare a proper repair, not a sealant patch, against the installed cost of a new unit. The ranges below reflect typical 2026 residential pricing in the Greater Toronto Area on a pitched asphalt shingle roof.
| Work | Typical 2026 cost | What you get |
|---|---|---|
| Head flashing rebuild | $450 to $950 | One detail corrected |
| Full re-flash of a sound unit | $700 to $1,600 | All four sides corrected |
| Roof deck repair around the opening | $300 to $900 | Sound substrate for fasteners |
| Fixed unit, supplied and installed | $1,600 to $2,900 | New unit, new flashing, new warranties |
| Solar powered fresh air unit, installed | $2,900 to $4,800 | Ventilation, rain sensor, blind options |
| Interior shaft drywall, tape and paint | $350 to $1,100 | Applies to either path |
The working rule is straightforward: once the proposed repair approaches roughly half the installed cost of a new unit, replacement is the better value. You are not just buying glass, you are buying a fresh manufacturer product warranty and a fresh workmanship warranty on the roof penetration, and neither of those comes with a repair to a twenty five year old assembly.
Apply that rule to skylight replacement Aurora quotes carefully, though. A repair at $700 against a replacement at $2,600 is genuinely worth doing if the glazing is clear and the frame is sound. The same repair on a unit that already fails question one or question three is money spent to delay an outcome you have already reached.
Question Five: What Do You Want The Room To Do?
This is the skylight replacement Aurora question nobody asks and everyone should. A repair returns the room to exactly what it was. A replacement is a chance to change it, and because the labour is largely identical whichever unit goes in, the incremental cost of a better one is small.
Consider whether you want ventilation. A venting or solar powered unit over a bathroom or kitchen removes humidity at its source, and a rain sensor closes it automatically. Consider the glazing package: a laminated inner pane is the upgrade we recommend most often above any living space, and a low emissivity coating with argon fill cuts solar heat gain without dulling the daylight, which matters as autumn light levels drop. Consider blinds, which are difficult to retrofit into a deep shaft later and straightforward to specify now.
Consider size and position as well. An existing opening is not sacred. If the room would be better served by a larger unit or by a second one on the opposite side of the ridge, the time to discuss it is at quotation. It is also worth asking whether a windowless hallway or ensuite nearby would benefit from a sun tunnel skylight installed on the same visit, since the setup cost is already being paid.
Ten Year Cost Of Ownership: The Two Paths Compared
A skylight replacement Aurora decision looks different over a decade than it does in a single quote. The comparison below is illustrative rather than a promise, but it reflects the pattern we see on units that are already marginal.
| Over ten years | Keep repairing a marginal unit | Replace now |
|---|---|---|
| Typical outlay | Two or three repairs at $450 to $1,600 each | One installation at $1,600 to $4,800 |
| Interior repairs | Often repeated drywall and paint | Once, at the time of installation |
| Warranty position | None on an out of warranty unit | Product plus workmanship warranty |
| Energy performance | Unchanged, older glazing | Low emissivity, argon, laminated inner pane |
| Risk of interior damage | Recurring | Low |
| Disruption | Repeated visits | One day, usually |
The line to watch is the interior one. Repeated drywall repair in a shaft is not expensive in itself, but it is annoying, it never looks quite right after the third time, and it usually costs more in aggregate than people expect.
Aurora Homes And What We Typically Find
Aurora covers several building eras and each one produces a recognisable pattern of skylight replacement Aurora enquiries. Older homes in the town’s historic central neighbourhoods frequently have units added later during renovations, and retrofit installations vary a good deal in quality, so flashing faults show up more often on those. Where the retrofit was done well and the glazing is clear, a repair can be very good value.
Subdivisions built through the 1970s and 1980s often carry original acrylic dome units on site built timber curbs. Acrylic yellows and goes brittle with ultraviolet exposure, and those curbs rarely meet modern flashing standards, so these fail questions one and two together and are replacement candidates almost without exception. The larger communities built from the 1990s onward generally have glass units on steeply pitched roofs above stairwells, ensuites and family rooms, now at the age where the seal governs. Estate properties toward the western edge of town tend to have bigger openings, higher roofs and deeper shafts through vaulted ceilings, which lengthens the interior part of the job.
Because the stock varies so much, no honest quote comes over the phone. You can read more about how we work locally on our skylight installation and repair in Aurora page, and our skylight replacement service page sets out the standard scope of a unit swap.
What Replacement Involves And How Long It Takes
If the five questions point to replacement, skylight replacement Aurora work itself is less disruptive than most people expect.
| Scope | On site time | Notes |
|---|---|---|
| Single unit, existing opening | 4 to 7 hours | One day, no deck repair |
| Two units, same roof plane | 1 full day | Shared setup lowers cost per unit |
| Unit plus deck and shaft repair | 1 to 2 days | Painting follows separately |
| Upsizing the rough opening | 2 days | Framing change, permit likely |
| Adding a sun tunnel on the same visit | Add 3 to 5 hours | No shaft to frame or finish |
The skylight replacement Aurora sequence is consistent: protect the room and sheet the ceiling opening, lift shingles and remove the old unit, inspect and repair the deck, set and fasten the new skylight to the manufacturer instructions, rebuild the flashing from the bottom up with a saddle at the head where the run above requires one, restore shaft insulation and air sealing, patch drywall, then water test in stages before clean up.

Getting A Quote You Can Actually Compare
Two quotes for skylight replacement Aurora work are only comparable if they describe the same job. Ask every contractor to put four things in writing: the unit model number, the flashing kit, whether removal and disposal are included, and what happens to the interior drywall. Then ask a fifth question: what is the rate if the roof deck turns out to be soft? Nobody can know that until the unit is out, and a contractor who prices the known work firmly and states a rate for the unknown is being straight with you.
Be wary of a quote that is dramatically lower than the others. In our experience the gap is usually the flashing kit, the disposal, or the interior finishing, and those reappear as extras once the roof is open. A written scope beats a low headline number every time.
Finally, check the permit position. A like for like swap in the existing opening generally does not require a building permit in Ontario, while enlarging an opening or altering framing usually does, and truss members must never be cut without a design from a qualified professional. Confirm with the Town of Aurora building department before work is scheduled. Toronto Skylight Installers quotes on that basis and supplies both a manufacturer warranty and a written workmanship warranty on completion.
How do I know whether to repair or replace my skylight?
What does skylight replacement Aurora work cost in 2026?
Is there a simple rule for when repair stops being worthwhile?
Should I replace the skylight when I replace the roof?
Why does my skylight drip when it has not rained?
Is autumn a good time to do this work?
Book A Skylight Replacement Aurora Assessment Before The Wet Season
If your skylight has fogged, stained the shaft, or been repaired more than once, a site visit will take the five questions above and give you a straight answer rather than a default recommendation. Toronto Skylight Installers carries out skylight replacement Aurora projects with a named unit, a named flashing kit, clear provisional pricing for deck and shaft work, a staged water test and a written workmanship warranty.
Call us today at (416) 365-7557 or request a free consultation while conditions still favour clean flashing work.
Proudly serving Aurora and communities across the Greater Toronto Area.
